FUEL INJECTOR HARNESS CONNECTOR, (sold as single injector end)

since your harness connectors have been through the wringer, here are some replacements.

After 30 years, your connectors are getting crispy and brittle and the wires have seen so many heat cycles, the insulation is hard cracked. The “last guy” broke the plastic or lost the wire to keep in in place (it’s never you, is it?). You can finally get rid of the janky zip-ties you are using now.

Don’t let a broken harness connector cause a hard-to-find drivability issue. A loose or broken connector can cause the injector not to pulse causing rough idle, lean run and a list of other issues.

**YES! POLARITY MATTERS! Keep track of which wire goes to which side of the harness connector/injector. Soldering is highly recommended along with shrink tubing and proper insulation. Pay attention to the polarity BEFORE you hack up your harness!

1989-1995 rounded connector type include connector and 7” of pigtail wires and some shrink tubing.

SORRY, NOT AVAILABLE FOR 1988

Available one at a time or a set of 4