fuel injector harness connector (1984-1987

IMG_0726.jpeg
IMG_0727.jpeg
IMG_0724.jpeg
IMG_0726.jpeg
IMG_0727.jpeg
IMG_0724.jpeg

fuel injector harness connector (1984-1987

$15.00

finally! non-crispy connector ends for you!

Quantity:
Add To Cart

fuel injector harness connector

**also fits your cold start injector and your cold start thermo-time switch (for the 1984-1987 (or up to 1988 4Runner))

since your harness connectors have been through the wringer, here are some replacements.

After 30 years, your connectors are getting crispy and brittle and the wires have seen so many heat cycles, the insulation is hard cracked. The “last guy” broke the plastic or lost the wire to keep in in place (it’s never you, is it?).

Don’t let a broken harness connector cause a hard-to-find drivability issue. A loose or broken connector can cause the injector not to pulse causing rough idle, lean run and a list of other issues.

**YES! POLARITY MATTERS! Keep track of which wire goes to which side of the harness connector/injector. Soldering is highly recommended along with shrink tubing and proper insulation. Pay attention to the polarity BEFORE you must your harness!

1984-1987 square connector type include connector, wire clip, 7” of pigtail wires and some shrink tubing.

sorry, not for 1988 injectors.